When you perform a server-side image backup using the Backup utility (dbbackup) by specifying the -s option, or by using the BACKUP DATABASE statement, a parallel database backup is performed. Parallel backups use physical device-level parallelism to decrease the overall time required to complete a backup operation. Parallel backups are not supported on Windows Mobile.
The database server creates a reader thread for each drive on which database files are stored. A writer thread is created for the destination drive where the backup directory is located. Using separate readers and writers allows I/O operations to be performed in parallel, instead of sequentially.
The performance of a parallel backup is limited by the slowest component in the system. It is typically a physical disk, but it could also be other components, such as the I/O controller or the system bus. Each of these components has a maximum rate at which they can transfer data.
The BACKUP DATABASE statement and the Backup utility (dbbackup) provide options that let you configure the behavior of a parallel backup, including:
when and how the checkpoint log is copied
the maximum number of pages used at a time to transfer data from the database server to dbbackup (only available when using dbbackup)
adding more writers (BACKUP statement only)
Backups should always be made to a separate physical drive. This provides a performance benefit from the I/O parallelism, and also improves the safety of the data in the event of a hardware failure.
Discuss this page in DocCommentXchange.
|Copyright © 2012, iAnywhere Solutions, Inc. - SQL Anywhere 12.0.1|