Server-side settings configured using the Notifier configuration file

A Notifier configuration file can be created using a text editor, or it can be generated from property and event settings exported from Sybase Central. See Setting up a Notifier, gateway, or carrier using Sybase Central.

To view the layout of a typical Notifier configuration file, open the %SQLANYSAMP16%\MobiLink\template.Notifier template file. The template file provides examples for configuring server-side properties and events.

When you have configured the necessary settings, save the Notifier configuration file and load your server-side properties and events into the MobiLink server.

Property = Value

Notifier(NotifierName).Event = \
# Replace this text with SQL script.           \
# Be sure to put a backslash (\) at            \
# the end of every line of code                \
# if your event requires multiple              \
# lines of text.

Notifier(NotifierName).Property = Value

# For Device tracking gateways:
DeviceTracker(DeviceTrackerName).Property = Value
# For SMTP gateways:
SMTP(SMTPName).Property = Value
# For SYNC gateways:
SYNC(SYNCName).Property = Value
# For UDP gateways:
UDP(UDPName).Property = Value

Carrier(CarrierName).Property = Value

To load a Notifier configuration file into the MobiLink server, run mlsrv16 from the command line with the -notifier option specified. For example, to use the server-side settings defined in a CarDealer.Notifier configuration file, run the following command:

mlsrv16 ... -notifier "c:\CarDealer.Notifier"

If a file is not specified, the config.Notifier file is loaded by default.

For more information about the mlsrv16 -notifier option, see -notifier mlsrv16 option.

Note

To use the default SYNC gateway, you cannot store server-side settings in a Notifier configuration file. You must store them in the ml_property system table using an alternative method. See MobiLink server settings for server-initiated synchronization.

The backslash ( \ ) is the escape character. The following is a list of common escape sequences that you can use in a Notifier configuration file:

Escape sequence	Description
\b	Backspace
\t	Tab
\n	Linefeed
\r	Carriage return
\"	Double quote ( " )
\'	Single quote ( ' )
\\	Backslash ( \ )
\e	Escape

Unicode escape sequences are of the form \uXXXX while ASCII escape sequences are of the form \xXX, where each X represents a hexadecimal digit.

When editing a property or event that requires multiple lines of text, add a single backslash character ( \ ) at the end of each line.